basics:abbreviations

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
basics:abbreviations [2021/11/07 10:04]
nmerdan
basics:abbreviations [2021/11/07 17:54] (current)
nmerdan
Line 20: Line 20:
 | airConCtl | .................................. | | | airConCtl | .................................. | |
 | airConSwitch | Flag representing if the air condition switch is active | | | airConSwitch | Flag representing if the air condition switch is active | |
-| alsCal | .................................. | |+| alsCal | Currently active antilag calibartion | |
 | alsDrvAddWheelSpin | .................................. | | | alsDrvAddWheelSpin | .................................. | |
 | alsEnableSwitch | .................................. | | | alsEnableSwitch | .................................. | |
Line 103: Line 103:
 | calUpSwitch | Calibration switch for next calibration | | | calUpSwitch | Calibration switch for next calibration | |
 | camRaw | raw value of teeth on cam shaft | | | camRaw | raw value of teeth on cam shaft | |
-| carCode0X | .................................. | |+| carCode0X | Custom car codes used in PNP kits Each of them is explained in the PNP kit manual |
 | ccp1 | Crank case pressure | | | ccp1 | Crank case pressure | |
 | ccp1Trip | Crank case pressure trip active | | | ccp1Trip | Crank case pressure trip active | |
Line 192: Line 192:
 | dbwLimitLimp | Drive by wire limit in limp mode | | | dbwLimitLimp | Drive by wire limit in limp mode | |
 | dbwLimitPit | Drive by wire limit when pit lane speed limiter is active | | | dbwLimitPit | Drive by wire limit when pit lane speed limiter is active | |
-| dbwLimitRevLimit | .................................. | |+| dbwLimitRevLimit | Drive by wire limit when rev limiter is active | |
 | dbwMltCalSw | Drive by wire multiplier by calibration switch | | | dbwMltCalSw | Drive by wire multiplier by calibration switch | |
 | dbwStatus | Drive by wire system status | | | dbwStatus | Drive by wire system status | |
Line 245: Line 245:
 | eht | Engine housing temperature sensor | | | eht | Engine housing temperature sensor | |
 | enableSwitch | Engine run switch | in off position, ignition and injection outputs are disabled.| | enableSwitch | Engine run switch | in off position, ignition and injection outputs are disabled.|
-| enableSwitchA | .................................. | | 
 | engineEnable | Engine/ECU running state | | | engineEnable | Engine/ECU running state | |
 | engineStopTimer | .................................. | | | engineStopTimer | .................................. | |
  • basics/abbreviations.txt
  • Last modified: 2021/11/07 17:54
  • by nmerdan